Gtco Roll-Up II - Users Guide User Manual download pdf (Page 42)

Roll-Up II 42

CalComp Emulation Commands

Roll-Up II recognizes a subset of the CalComp 9500 command set. Space does not permit a

detailed description of CalComp commands. However, most of the commands in this

subset have equivalent Roll-Up II commands. For further information about the operation

of those commands, please refer to the Roll-Up II command or function description in the

GTCO CalComp by Turning Technologies Roll-Up II Command Summary.

NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the

codes listed here. Commands can be strung together by substituting an @ character for

the <ESC>% sequence after the first command and postponing the <CR> until the end of

the multiple command string.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 69 70

No comments

Gtco Roll-Up II - Users Guide User Manual Page 42