Gtco Cordless Roll-Up - Users Guide User Manual Page 40
- Page / 74
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Cordless Roll-Up 40
Read Current Coordinate
Code: hex 02 (Ctrl-B)
The Read Current Coordinate causes the Cordless Roll-Up to output a coordinate while it is
in Remote Request Mode. This command can be sent to the Cordless Roll-Up only when it
is digitizing and only when Remote Request Mode is in Command Mode. Please note that
this command is not two ASCII characters. It is the one-byte-long STX character, CTRL-B
(hex 02). Cordless Roll-Up responds to the Read Current Coordinate command by
transmitting one format.
Set Increment Value
Code: IV
In Line Incremental and Continuous Incremental modes, the Cordless Roll-Up outputs a
coordinate when the transducer is moved beyond a certain incremental distance in either
the X or Y direction. The default increment is 0.01”. The Set Increment Value command
allows the user to select the distance which the transducer must move to initiate
coordinate output. It works as follows:
1. Enter Command Mode by sending a CTRL-A.
2. After receiving the > prompt, send IV and a <CR> (hex 0D).
3. The Controller will respond with a <.
4. After receiving the <, send a three-digit string ranging from 000 to 999. This string
represents an increment value of 0.000 to 0.999 inch.
5. When the Controller receives the last character it will respond with a > prompt and
await the next command.
Send Coordinates 0,0 When Transducer is Out of Active Area
No Output When Transducer is Out of Active Area
Code: OP
Code: IP
Certain situations require that the Cordless Roll-Up be able to send a coordinate when the
transducer is out of the active area. Command OP permits coordinates to be sent under
this condition. Since valid coordinates are not available when the transducer is out of the
active area, coordinates 0,0 are substituted in the format. When this command has been
executed, digitizing modes operate normally, whether the transducer is in the active area
or not. Command IP returns Cordless Roll-Up to the default condition, in which
coordinates are sent only when the transducer is in the active area.
Related products and manuals for Computer hardware Gtco Cordless Roll-Up - Users Guide
(70 pages)
(37 pages)
(18 pages)Canon ELPH115IS IXUS 132 manuals
Owner’s manuals and user’s guides for Gateways/controllers Canon ELPH115IS IXUS 132.
We providing 1 pdf manuals Canon ELPH115IS IXUS 132 for download free by document types: User's Guide
Comments to this Manuals